Hamarat

Road Sweeper

Trailed Mechanical Sweeper
2 m³

همارت

مكنست طرق

مكنسة طرق ميكانيكية مقطورة تثبت خلف المركبة
سعة 2 م³

Hamarat offers the optimum balance among high performance, quality, low cost, and environmental impact.
Machine is capable of sweeping and collecting sand, stones or other debris with 2 m³ ideal capacity and loads waste material quickly and directly from the road into its own hopper.
Standard model of Hamarat without engine uses the PTO of the tractor and there is no additional fuel consumption. Any kind of tractor with 33 KW is sufficient to trail the machine. The connection between machine and tractor can be handled easily in a short time.
Optionally, self-engine model allows our partners to use forklift, pickup or other vehicles to trail the machine if tractor is not available on hand. Additional engine room including 23,8 KW engine with 50LT fuel tank is located on the rear of hamarat.
Ergonomic and user-friendly pendant control unit connected via a flexible cable allows the driver both to run all the sweeping functions inside the tractor cabin and to drive the tractor simultaneously.
It needs less components comparing with other sweeper models. All critical controls are contained in one area. The ease of access to this equipment aids diagnostic checks quickly. Due to compact design of the subgroup, it is very easy to change the brushes, and to clean jet nozzles, and water filter.
Washing gun equipped on the machine can be used for cleaning the machine after sweeping, irrigation of trees and plants, washing the pavements or agricultural disinfection purposes by using special chemicals.
Waste discharging is carried hydraulically by the pendant control unit. Its hopper is designed to enable discharge of debris into any waste container available on road. It doesn’t need to transport wastes to waste disposal areas.

تقدم Hamarat التوازن الأمثل بين الأداء العالي والجودة والتكلفة المنخفضة والتأثير البيئي.

الماكينة قادرة على كنس وتجميع الرمل أو الأحجار أو المخلفات وتتسع لـ 2 م3 فهي مثالية وتحمل النفايات بسرعة وبشكل مباشر من الطريق إلى حاويتها الخاصة.

النموذج القياسي للهامارات بدون محرك يستخدم PTO للسحب ولا يوجد استهلاك إضافي للوقود. أي نوع داركتر بقدرة 33 كيلووات يكفي لسحب الماكينة. يمكن معالجة الاتصال بين الماكينة والدركتر بسهولة في وقت قصير.

بشكل اختياري ، يسمح نموذج المحرك الذاتي لشركائنا باستخدام الرافعة الشوكية أو الشاحنة أو المركبات الأخرى لسحب الماكينة إذا لم يكن الداركتر متاحًا في متناول اليد. توجد غرفة محرك إضافية بما في ذلك محرك 23،8 KW وخزان وقود سعة 50 لترًا في الجزء الخلفي من مناطق همارت.

تتيح وحدة التحكم المعلقة المريحة وسهلة الاستخدام المتصلة عبر كابل مرن للسائق تشغيل كل وظائف المسح داخل كابينة الجرار وقيادة الجرار في نفس الوقت.

المكنسة تحتاج إلى مكونات أقل مقارنة بطرازات الكنس الأخرى. يتم تضمين كافة الضوابط الهامة في منطقة واحدة. تساعد سهولة الوصول إلى هذا الجهاز على الفحص التشخيصي بسرعة. نظرًا للتصميم المدمج للمجموعة الفرعية ، من السهل جدًا تغيير الفرش وتنظيف فوهات النفاثات وفلتر المياه.

يمكن استخدام مسدس الغسل المجهز على الماكينة لغسيل المكينة بعد الكنس ، وري الأشجار والنباتات ، وغسل الأرصفة أو أغراض التطهير الزراعي باستخدام مواد كيميائية خاصة.

يتم تفريغ النفايات هيدروليكيًا بواسطة وحدة التحكم المعلقة. تمت مراعاة تصميم صندوق النفايات لسهولة تفريغ المخلفات في أي حاوية نفايات متاحة على الطريق. لا تحتاج إلى نقل النفايات إلى المناطق المخصصة للتخلص من النفايات.

 

 

Browse the catalog

تصفح الكتلوج

Get the best cleaning

equipment

11 + 9 =

تواصل مع المتخصصين

اتصل بنا

+966 58 257 2671

ارسل رسالة

info@glossypath.com

تواصل معنا

الرياض , المملكة العربية السعودية

2671 257 58 966+

info@glossypath.com